1、TGC-A322143-01-1SPRING AIRLINES MEDForm.MP.001 版次Revi00第 1 頁，共 4 頁標題詳細檢查前起落架，前撐桿，上部板，下連桿和萬向接頭-外部表面（不包括表面的涂層和襯套邊緣）工作者檢驗者TitleDETAILED INSPECTION OF NOSE LANDING GEAR, FORESTAY, UPPER PANEL, LOWER LINK AND UNIVERSAL JO -EXTERNAL SURFA , EXCEPT WHERE COVERED BY DRESSINGS AND BUSH FLANGESMech.Insp.WARNI

2、NG:MAKE SURET THE GROUND SAFETY-LOCKS ARE INITION ON THE LANDING GEAR.警告： 確定地面安全銷安裝在起落架上WARNING: MAKE SURET THE TRAVEL RANGES OF THE LANDING GEAR ARE CLEAR.警告：確定前起落架行程范圍內無阻礙。Job Set-up/準備Safety Precautions/安全預防Make suret theROUND LOCK,NLG (D23080000) or PIN-LOCKING (MZ23080000) , asternative, is ini

3、tion.確保前起落架地面安全鎖銷在位,鎖銷件號 D23080000 或 MZ23080000 二選一。he cockpit, on the right-center instrument panel 400VU:- Put a WARNING NOTI) inition tols not to operate the landing-gear normal control-lever.在駕駛艙右側 400VU 面板上：-放置一警告牌來告知其他人不要操作起落架正常控制手柄。(3) On the steering handwheels (CAPT and F/O) and on the brak

4、e pedals:- Put a WARNING NOTI) inition tols not to operate them.輪轉彎手輪（機長和副駕側）和剎車腳蹬：-放置警告裝置來通知其他人不要操作這些。(4) Put SAFETY BARRIER(S) inition.在工作區域設置安全圍欄B. Aircraft Maenance Configuration /飛機構型(1)he cockpit, on the right-center instrument panel 400VU:- Make suret the landing-gear normal control-lever ish

5、e DOWNition.在駕駛艙右側 400VU 面板：-確保起落架正常控制手柄在 DOWN 位置(2) On the rudder/trim parking-brake panel 110VU:- Make suret the free-fall control handle ishe usualition.在方向舵/配平停留剎車面板 110VU 上：-確保重力放起落架手柄在正常位置TGC-A322143-01-1SPRING AIRLINES MEDForm.MP.001 版次Revi00第 2 頁，共 4 頁標題詳細檢查前起落架，前撐桿，上部板，下連桿和萬向接頭-外部表面（不包括表面的涂

6、層和襯套邊緣）工作者檢驗者TitleDETAILED INSPECTION OF NOSE LANDING GEAR, FORESTAY, UPPER PANEL, LOWER LINK AND UNIVERSAL JO -EXTERNAL SURFA , EXCEPT WHERE COVERED BY DRESSINGS AND BUSH FLANGESMech.Insp.(3) Make suret CHOCK - WHEEL(S) are inition on the main landing gear.確保主起落架的輪檔已擋好。C. Get Acs/接近Open the main do

7、ors of the NLG (Ref. AMM TASK 32-22-00-010-001) .打開前起落架艙門，參考 AMM TASK 32-22-00-010-001Put an ACS PLATFORM 3M (10 FT)- ADJUSTABLE inition.在工作區域放置工作梯2.Procedure /程序(Ref. Fig. 610/TASK 32-21-00-991-019 SHEET 610.1)A. Detailed Inspection of the External Surfaof the Forestay Uppanel, Lower Link and Unive

8、rsal Joof the Nose Landing Gear詳細檢查前起落架撐桿上部板，下部連桿和萬向接頭Do a detailed visual inspection of the forestay uppanel and look for signs of:Damage to the protective finishDents and scratchesCorro.詳細目視檢查撐桿上部板（forestay uppanel），確認沒有：-損傷到保護層-凹坑和刮傷-腐蝕檢查結果(Checking result)：處理措施(Maenance)：Do a detailed visual ins

9、pection of the lower link and look for signs of:Damage to the protective finishDents and scratchesCorro.詳細目視檢查下部連桿（lower link），確認沒有：-損傷到保護層-凹坑和刮傷-腐蝕檢查結果(Checking result)：處理措施(Maenance)：RIITGC-A322143-01-1SPRING AIRLINES MEDForm.MP.001 版次Revi00第 3 頁，共 4 頁標題詳細檢查前起落架，前撐桿，上部板，下連桿和萬向接頭-外部表面（不包括表面的涂層和襯套邊緣

10、）工作者檢驗者TitleDETAILED INSPECTION OF NOSE LANDING GEAR, FORESTAY, UPPER PANEL, LOWER LINK AND UNIVERSAL JO -EXTERNAL SURFA , EXCEPT WHERE COVERED BY DRESSINGS AND BUSH FLANGESMech.Insp.Do a detailed visual inspection of the universal joand look for signs of:Damage to the protective finishDents and scr

11、atchesCorro.詳細目視檢查萬向接頭（universal jo），確保沒有：-損傷到保護層-凹坑和刮傷-腐蝕檢查結果(Checking result)：處理措施(Maenance)：NOTE: If you find any accidental case ,Please inform the ET of SPRING.注：如果發現任何其他情況，請聯系春秋工程技術室。RIIClose-up /結束Close Acs /結束Close the main doors of the NLG (Ref. AMM TASK 32-22-00-410-001) .參考 AMM TASK 32-22-00-410-001,關閉前起落架艙門Remove the acs platform(s).撤走工作梯Put the aircraft back to its initial configuration. /恢復飛機到初始構型Remove the warning noti).拆下警告牌Remove the safety barriers.撤除護欄Make suret the work area is clean and clear of tool(s) and ot